Toshiba portege r500 사용자 설명서

다운로드
페이지 255
171
If Something Goes Wrong
Problems when you turn on the computer
The computer displays the 
WARNING RESUME FAILURE
 message.
The computer was placed in Standby mode and the battery has 
discharged. Data stored in the computer’s memory has been lost. 
Data stored in the computer’s hard drive may not be affected.
Always save your data even when you are using Standby. If your 
battery fully discharges, information that has not been saved will be 
lost. Your computer can be configured to warn you when the battery 
is running low see 
If you are running on battery power, it is recommended that you do 
not leave the computer in Standby mode for long periods of time.
To charge the battery, leave the computer plugged into a live wall 
outlet for several hours. For more information see 
The computer displays the 
Non-System disk 
or
 disk error
 
message
Make sure there is no diskette in the optional external diskette 
drive. If there is a diskette in the drive, remove it and press any key 
to continue. If pressing any key does not work, press 
Ctrl,
 
Alt
, and 
Del 
to 
restart the computer. For more information see 
.
The AC power light is blinking. 
If the AC power light is blinking, try the following steps:
1
Cut off power to the computer by disconnecting the AC adaptor 
and removing the battery. The error condition will be 
interrupted, and the AC power light will stop flashing.
2
Put the battery back into the computer. Do not connect the AC 
adaptor. Try turning the computer on again. 
If the computer starts normally, the AC adaptor may be 
defective and will need to be replaced (see the Toshiba Web 
site at 
accessories.toshiba.com
). 
If the AC power light starts flashing, remove the battery, and 
continue with the steps below.
3
Connect the AC adaptor to the computer. Leave the battery out 
of the computer. Try turning the computer on again.