Toshiba satellite m110 사용자 설명서
59
Getting Started
Adding memory (optional)
5.375 x 8.375 ver 2.3
Do not try to remove a memory module with the computer
turned on. You can damage the computer and the memory
module.
turned on. You can damage the computer and the memory
module.
Do not remove the memory module while the computer is in
Standby or Hibernation mode. The computer could hang up
the next time you turn it on and data in memory will be lost. In
either of the above cases, the Standby configuration will not be
saved.
Standby or Hibernation mode. The computer could hang up
the next time you turn it on and data in memory will be lost. In
either of the above cases, the Standby configuration will not be
saved.
The following message appears when you turn on the power:
Warning: Resume Failure
Press Any Key to Continue
Press Any Key to Continue
If the computer hangs up when you turn it on, perform the
following: Press the power button and hold it down for at least
ten seconds, then turn the power on again.
following: Press the power button and hold it down for at least
ten seconds, then turn the power on again.
2
Pull the latches away from the memory module.
The memory module pops up slightly.
If your system has the memory modules stacked on top of one
another, you must remove the top module first before
removing/installing the bottom module.
another, you must remove the top module first before
removing/installing the bottom module.
1
Gently lift the memory module to a 30-degree angle and
slide it out of the slot.
slide it out of the slot.
NOTE