MiTAC w130 서비스 매뉴얼
16
WfM 2.0 and IEEE 802.3 compliant
LAN Connect Interface (LCI)
10/100 Mbit/sec Ethernet support
_
Integrated IDE Controller
Supports “Native Mode” register and interrupts
Independent timing of up to 4 drives, with separate primary and secondary
IDE cable connections
Ultra ATA/100/66/33, BMIDE and PIO modes
Tri-state modes to enable swap bay
USB
Includes three UHCI host controllers that support six external ports
New: Includes one EHCI high-speed USB 2.0 Host Controller that
supports all six ports
New: Supports a USB 2.0 high-speed debug port
Supports wake-up from sleeping states S1–S5
Supports legacy keyboard/mouse software
AC-Link for Audio and
Telephony CODECs
Supports AC ’97 2.3
New: Third AC_SDATA_IN line for three code support
New: Independent bus master logic for seven channels (PCM In/Out, Mic
1 input, Mic 2 input, modem in/out, S/PDIF out)
Separate independent PCI functions for audio and modem
Support for up to six channels of PCM audio output (full AC3 decode)
Supports wake-up events
Interrupt Controller
Support up to eight PCI interrupt pins
Supports PCI 2.2 message signaled interrupts
Two cascaded 82C59 with 15 interrupts
Integrated I/O APIC capability with 24 interrupts
Supports serial interrupt protocol
Supports processor system bus interrupt delivery
New: 1.5 V operation
with 3.3 V I/O
5 V tolerant buffers on IDE, PCI, USB overcurrent and legacy signals
Timers Based on 82C54
System timer, refresh request, speaker tone output
Power Management
Logic
ACPI 2.0 compliant
ACPI-defined power states (C1–C2, S3–S5 )
Supports Desktop S1 state (like C2 state, only STPCLK# active)
ACPI power management timer