Siemens MC35 사용자 설명서
AT Command Set
MC35_ATC_01_V05.00
Page 99 of 256
15.07.2002
"signal"
Signal quality (0-7 or 99 if not measurable). The
indicated value is the bit error rate of the signal
received. See also Chapter 4.46.
indicated value is the bit error rate of the signal
received. See also Chapter 4.46.
"service"
Service availability (0-1).
"sounder"
Sounder activity (0-1). The indicator provides in-
formation about tones generated in the ME. The
value 1 means for example:
Incoming call - ME is ringing.
Waiting call – ME generates waiting call tone (if
call waiting is enabled).
Outgoing call – ME generates Call Progress tone.
Outgoing call – ME generates BUSY tone.
The value changes to 0, when the tone stops.
formation about tones generated in the ME. The
value 1 means for example:
Incoming call - ME is ringing.
Waiting call – ME generates waiting call tone (if
call waiting is enabled).
Outgoing call – ME generates Call Progress tone.
Outgoing call – ME generates BUSY tone.
The value changes to 0, when the tone stops.
"message"
Unread short message(s) (0-1).
"call"
Call in progress (0-1). Voice und data calls only.
The indicator changes its value as soon as a call
has been established, for example when both in-
terlocutors are connected or when the call ends.
The indicator changes its value as soon as a call
has been established, for example when both in-
terlocutors are connected or when the call ends.
"roam"
Roaming indicator (0-1).
"smsfull"
A short message memory storage in the MT has
become full (1) or memory locations are available
(0); i.e. the range is (0-1).
become full (1) or memory locations are available
(0); i.e. the range is (0-1).
<value>
integer type value, in the range stated above for the corresponding
<descr>.
<descr>.
Reference
GSM 07.07
Note
· Only the indicators which are registered (see AT+CIND command), will be re-
ported if CMER is enabled.
· After CMER has been switched on, +CIEV URCs for all registered indicators
with their default value will be presented to the TE.
· While the ME is in online data mode, no URC will be displayed. Each +CIEV
URC is replaced with a Break (100 ms), and is stored in a buffer. Once the ME
goes into command mode (after +++ was entered), all URCs stored in the
buffer will be output.
Exception: For “message” indicator, please note that each incoming short mes-
sage will cause a Break.
goes into command mode (after +++ was entered), all URCs stored in the
buffer will be output.
Exception: For “message” indicator, please note that each incoming short mes-
sage will cause a Break.
· See AT+CIND in Chapter 4.19.