Yamaha DME8i-ES 사용자 설명서
Ref
erences
Other Functions
Connecting to an
External De
vice
A
udio I/O
Connection
Connecting to
a Computer
Contr
ols and
Connector
s
Intr
oduction to
the DME Satellite
Fore
w
o
rd
Audio I/O Connection
DME8i-ES/DME8o-ES/DME4io-ES Owner’s Manual
25
Analog Audio Connection ([INPUT] & [OUTPUT] Connectors)
The DME Satellite can directly input and output audio signals via the [INPUT] and [OUTPUT] connectors.
Wire the supplied Euroblock plugs (3P) as shown below. You can use DME Designer to set the head amplifier
gain and turn the phantom power on and off for each [INPUT] connector.
Wire the supplied Euroblock plugs (3P) as shown below. You can use DME Designer to set the head amplifier
gain and turn the phantom power on and off for each [INPUT] connector.
Cable preparation
Prepare cables to be attached to a Euroblock plug as shown below.
Euroblock plug connection
1.
Loosen terminal screws.
2.
Insert cables.
3.
Securely tighten terminal screws.
Pull the cables (not too strongly) to confirm that they are securely connected.
4.
Insert the Euroblock plug into the Euroblock
connector on the rear panel.
connector on the rear panel.
Be sure to use shielded cables.
Do not tin (plate with solder) the exposed sections of the cable.
NOTE
Use a slotted screwdriver with a blade width of about 3 millimeters to secure the cables to the
(3P) Euroblock plug.
Use a slotted screwdriver with a blade width of about 2 millimeters to secure the cables to the
(16P) Euroblock plug to connect to the [GPI] connector.
(3P) Euroblock plug.
Use a slotted screwdriver with a blade width of about 2 millimeters to secure the cables to the
(16P) Euroblock plug to connect to the [GPI] connector.
Shielded Cable
7mm
30mm
CAUTION
CAUTION
3mm
Loosen
Slotted Screwdriver
Euroblock Plug
Terminal Screw