Yamaha mfc10 사용자 설명서

Foot Controller

Press [FC EDIT], to edit the selected data type (the lamp
flashes) of the parameters set in the above procedure. It is
possible to edit the following types of data.

■

About Foot Switch Use

Foot switches can also be connected to the [FOOT CONTROLLER/SWITCH 2-5]
jacks located on the rear panel of the MFC10.

If a foot switch is connected, the set BANK MSB/MAX value will be transmitted via
MIDI when the foot switch is pressed. When the foot switch is released, the set
BANK LSB/MIN value will be transmitted via MIDI.

• Control Change (b) [STATUS=b0-bF]

DATA/CTRL

001-031, 033-120 Control Number

BANK MSB/MAX

000-127 MAX Value

BANK LSB/MIN

000-127 MIN Value

• After Touch (d) [STATUS=d0-dF]

DATA/CTRL

– – –

BANK MSB/MAX

000-127 MAX Value

BANK LSB/MIN

000-127 MIN Value

DATA/CTRL

– – –

BANK MSB/MAX

000-127 Pitch Bend MAX

BANK LSB/MIN

000-127 Pitch Bend MIN

• Pitch Bend (E) STATUS=E0-EF]

* The value of the Pitch Bend’s center pitch is 64.

Edit the parameters using the [INC/YES] or [DEC/NO]
buttons.

EDIT

STATUS
DATA/CTRL

BANK MSB/MAX
BANK LSB/MIN

TOGGLE ON-OFF
/NUMBER OF PGM

DEC
/NO

INC

/YES

±10

DEC
/NO

INC

/YES

±10

FC1

After the desired parameters have been edited in steps

and

press [WRITE/EXIT]. The Foot Controller’s number will flash
in the LED display.

Press [INC/YES] to execute the save operation or [DEC/NO]
to cancel.

• Another Memory Number can be easily edited by pressing [1]-[5] without exiting from the edit mode. You

must execute or cancel the save operation for the currently edited data (the current Memory Number will

flash) before proceeding to edit the new number. Use [INC/YES] to execute or [DEC/NO] to cancel the

save operation. If data has not been edited, the Memory Number will not flash and the newly selected

Memory Number will be shown in the display.

DEC
/NO

INC

/YES

±10

DEC
/NO

INC

/YES

±10