Escalade Sports 2l-6535-01 사용자 설명서
3
ASSEMBLY INSTRUCTIONS:
Figure 2
1. Make a mark on middle pole section (#27) at 4¼
inches from the top (tapered) end. See Figure 1.
Slide top pole section (#26) onto middle section
and seat securely by tapping the poles on a block
of wood. Seat the poles until there is no movement
or until the bottom edge of top pole reaches the
4¼" mark on middle pole. See Figure 1.
and seat securely by tapping the poles on a block
of wood. Seat the poles until there is no movement
or until the bottom edge of top pole reaches the
4¼" mark on middle pole. See Figure 1.
Figure 1
IMPORTANT! Make sure the pole sections are
aligned EXACTLY as shown in Figure 2 before
tapping them together! Once sections are seated
together, you will NOT be able to pull them apart!
2. Lay the top and middle pole assembly on flat ground and align the
bottom pole section (#28) with it as shown in Figure 2. Insert a
bolt #17 through a hole in the top pole section and one through a
hole in the bottom pole section as shown. Push the bolts through
until the head of both bolts contacts the pole. Allow the threaded
end of each bolt to rest on the ground. This will ensure proper
alignment of poles. If proper alignment is not achieved, your
backboard and goal will not be square with the ballast. See Figure
1A at right.
bolt #17 through a hole in the top pole section and one through a
hole in the bottom pole section as shown. Push the bolts through
until the head of both bolts contacts the pole. Allow the threaded
end of each bolt to rest on the ground. This will ensure proper
alignment of poles. If proper alignment is not achieved, your
backboard and goal will not be square with the ballast. See Figure
1A at right.
Carefully slide the pole sections together, keeping the holes
properly aligned. Now pick the sections up and tap them on a block
of wood until there is no movement or until the bottom edge of the
middle pole reaches the 4¼" mark on the bottom pole. Lastly,
remove the bolts #17 from the poles.
properly aligned. Now pick the sections up and tap them on a block
of wood until there is no movement or until the bottom edge of the
middle pole reaches the 4¼" mark on the bottom pole. Lastly,
remove the bolts #17 from the poles.
Figure 1A