Escalade Sports 2l-6423-03 사용자 설명서
ASSEMBLY INSTRUCTIONS:
Figure 1
1. Before putting any of the pole tubes together, mark
bottom pole (#1) and middle pole (#2) 6 inches from their
top end. (On the bottom pole, the top end is the end with
the single hole in it). See Figure 1.
top end. (On the bottom pole, the top end is the end with
the single hole in it). See Figure 1.
2. Align the upper pole (#3) with the middle pole (#2) making
sure the two holes near the flange of each pole face the
same direction as shown in figure 2, and slide them
together. Hit tubes on a piece of wood until there is no
more movement or until the bottom of the upper pole
reaches the 6" mark on the middle pole. Then align the
bottom pole (#1) with the middle pole (#2) (make sure
the weld seams in the poles line up) with your 6" mark on
the bottom pole toward the flange of the middle pole
(#2) as shown, and slide the sections together .
same direction as shown in figure 2, and slide them
together. Hit tubes on a piece of wood until there is no
more movement or until the bottom of the upper pole
reaches the 6" mark on the middle pole. Then align the
bottom pole (#1) with the middle pole (#2) (make sure
the weld seams in the poles line up) with your 6" mark on
the bottom pole toward the flange of the middle pole
(#2) as shown, and slide the sections together .
IMPORTANT! Make sure the pole sections are
aligned EXACTLY as shown in Figure 2 before
tapping them together! Once sections are seated
together, you will NOT be able to pull them apart!
Figure 2
3. Now lift tubes and pound them on a piece of wood to
secure. Hit the tubes until there is no more movement or
until the bottom end of the upper and middle tubes
reaches the 6 inch mark on the middle and lower tubes
respectively. Hit tubes a minimum of seven times. This is
a friction-locking joint and requires no hardware.
until the bottom end of the upper and middle tubes
reaches the 6 inch mark on the middle and lower tubes
respectively. Hit tubes a minimum of seven times. This is
a friction-locking joint and requires no hardware.
4. NOW MEASURE DOWN FROM MIDDLE HOLE IN TOP
POLE 102 INCHES, AND MAKE A MARK ON BOTTOM
POLE. YOU WILL USE THIS MEASUREMENT IN STEP 20.
SEE ILLUSTRATION BELOW.
POLE. YOU WILL USE THIS MEASUREMENT IN STEP 20.
SEE ILLUSTRATION BELOW.