Epson 3010E 사용자 설명서
72
Problem Solving
3D content does not display or does not display correctly.
■
Press the
2D/3D
button on the remote control to switch to 3D viewing mode, if
necessary.
■
Make sure that you are within the 3D viewing range (see page 12).
■
Check that your video device and media are both 3D-compatible. Refer to the
documentation that came with your video device for more information.
documentation that came with your video device for more information.
■
Press the
Menu
button on the remote control, select the
Signal
menu, then
3D Setup
,
then select
3D Format
. Make sure that the
Auto
option is selected.
■
Make sure that the
Inverse 3D Glasses
option is set to
No
■
If your video device is connected with the WirelessHD Transmitter (PowerLite Home
Cinema 3010e only), see page 75.
Cinema 3010e only), see page 75.
Only part of the picture is displayed, or the picture is distorted.
■
Press the
Aspect
button on the remote control to select a different aspect ratio (see
■
If the Aspect is set to
Zoom
, you may need to use the
Zoom Caption Pos.
option to see
■
Check the
Overscan
to make sure it’s adjusted correctly (see page 52).
■
Use the
Position
setting to reposition the image on the screen (see page 52).
■
If you’ve connected a computer and you see only half the image, make sure the
computer’s Dual Display setting is turned off.
computer’s Dual Display setting is turned off.
■
If part of the image is cut off, reset the projector settings (see page 51).
■
If your video device is connected with the WirelessHD Transmitter (PowerLite Home
Cinema 3010e only), make sure you are within the wireless transmission range (see
page 56).
Cinema 3010e only), make sure you are within the wireless transmission range (see
page 56).
You’re using a computer and no picture appears on the screen.
If you’re using a Windows
®
laptop:
■
Press the function key that lets you display on an external monitor. It’s often labeled with
an icon such as
an icon such as
, but it may also be labeled
CRT/LCD
. You may have to hold down
the
Fn
key while pressing it. Check your laptop’s manual or online help.
On most systems, the
key lets you toggle between the LCD screen and the
projector, or display on both at the same time. Allow a few seconds for the projector to
sync up after pressing it.
sync up after pressing it.
pl3010_3010e_UG.book Page 72 Wednesday, September 7, 2011 6:28 PM