Sanyo VCC-3944 사용자 설명서
8
English
CONNECTIONS
Basic connection for monitoring or recording
The peripheral devices (VCR, monitor, lens, etc.), AC
adaptor and cables are sold separately.
adaptor and cables are sold separately.
1
Make the video signal connection between the camera
and the monitor or time lapse VCR.
and the monitor or time lapse VCR.
2
Connect the power supply.
• If using a commercially-available 24 V AC adapter,
always be sure to connect the ground wire (18AWG or
higher) to the ground terminal. (Figure 1)
higher) to the ground terminal. (Figure 1)
• If using a 12 V DC power supply, make the connections
as shown in Figure 2.
Note:
• In order to avoid any problems with the camera and the
power supply, take sufficient care to ensure that the
polarities are correct when connecting the power supply.
polarities are correct when connecting the power supply.
3
Insert the plug of this power cord into a wall outlet.
The POWER indicator (A) will light. Adjust the picture on
the monitor using the Brightness and Contrast controls etc.
the monitor using the Brightness and Contrast controls etc.
■
■
■
■
Coaxial cable type and maximum length
• Cable type RG-59U (3C-2V), 250 m maximum.
• Cable type RG-6U (5C-2V), 500 m maximum.
• Cable type RG-11U (7C-2V), 600 m maximum.
CAUTION:
• The RG-59U type cable should not be run through electrical
conduits or through the air.
• Use CCTV/Video-grade coaxial cable.
GND AC24V
DC12V
GND AC24V
DC12V
(Video signal connections)
: VIDEO IN
: VIDEO OUT
: VIDEO IN
: VIDEO OUT
(A)
1
24 V AC connection
Figure 1
Figure 2
12 V DC connection
L5AF2_US.book 8 ページ 2002年12月20日 金曜日 午後1時48分