AstroStart 2305a 사용자 설명서

The following table shows the effect that each zone has on the rearming cycle. 

 

Hood 
Doors 
Additional sensor (trunk) 
Shock sensor 

These four zones prolong rearming cycle as long as they remain in violation. 

Ignition 

Activated by ignition key:  

Cancels rearming 

Activated by remote starter:  

No effect 

Warning No 

effect 

Applying brakes or ignition key in RUN position cancels rearming (until a door is opened, which causes rearming cycle to 
restart from the beginning). 

See also ‘Temporary Valet Mode’ (page 14) and ‘Dome Light Duration’ (page 19). 

You can disarm only with remote control by pressing the 

 

button (see Table of Commands on page 6). 

System is disarmed immediately and restarts rearming cycle from the beginning. 

You can terminate alarm condition by pressing 

 button (2 sec.), which also disarms system. Pressing the 

 

button 

(2 sec.) or the stop command, will terminate alarm condition without disarming system.  

When the alarm is armed, one chirp of the siren and/or flash of the parking lights means that all protection zones are in 
normal condition and system is ready.  
The remote control lights the   button and emits one Beep.  
Three chirps or flashes means that one or more zones are in violation (i.e. at least one door is opened). At that time, the 
remote send the same confirmations. 
Once the zone is corrected (i.e. door closed), the system sends another confirmation (one chirp or flash if all zones are in 
normal condition, three chirps or flashes if another zone is in violation). 
If a zone is in violation when system is armed manually (using remote) and the cause of the violation is not corrected, the 
alarm will still arm but this zone will not be able to generate an alarm condition. See also ‘Dome Light Duration’ on page 19. 
When you disarm the alarm, two chirps or flashes indicate that no one tried to break into or do anything to your vehicle, and 
four chirps or flashes indicate that an alarm condition occurred during your absence. 
The following table summarizes this section. 

1 chirp  

System armed, no zone in violation. 

2 chirps 

System disarmed, no violation detected. 

3 chirps 

System armed with zone in violation. Indicator light indicates which zone. 

4 chirps 

System disarmed with violation detected. Indicator light or remote transmitter indicates cause of alarm
condition. 

Indicator light flashes a specific number of times to indicate different alarm conditions when arming and disarming the 
system (according to the options programmed at time of installation). 
It can also act as a deterrent if installed in a place visible from outside the vehicle. 
DURING ARMING Indicator flashes codes for zones in violation (i.e. one door is opened). 
Only one code is shown at a time. If more than one zone is in violation during arming, code changes when zone shown is 
corrected (example: door closed).  
DURING DISARMING Indicator flashes code for last zone that generated the alarm condition. 

Code is shown when you press  

  

button. This code is repeated until you apply the brakes.