Seventeam ST-1000E-AD 전단

ST-1000E-AD

Ver. 0.1

u INPUT CHARACTERISTICS:

§ VOLTAGE: 100VAC - 240 VAC
§ FREQUENCY: 50

- 60

§ INPUT CURRENT:

16.0 A – 9.0A

FOR 100-240VAC

§ INRUSH CURRENT: 160 A MAX FOR 230VAC

90 A MAX FOR 115VAC

u SPECIFICATION:

§  EFFICIENCY: 83% TYPICAL, FULL LOAD  CONDITION AT 230 VAC INPUT.
§  POWER GOOD SIGNAL: ON DELAY TIME 100 ~ 500 ms, OFF DELAY TIME 1ms.
§  HOLD UP TIME: 17ms AT 25℃ FULL LOAD CONDITION AT 115/230 VAC INPUT.
§  OPERATING TEMPERATURE RANGE: 0℃ ~ 50℃.
§  REMOTE ON/OFF CONTROL: THE POWER SUPPLY OUTPUT SHALL BE ENABLED WITH AN

ACTIVE-LOW TTL SIGNAL. WHEN TTL SIGNAL IS LOW, THE DC OUTPUTS ARE TO BE ENABLED.
WHEN TTL SIGNAL IS HIGH OR OPEN CIRCUITED, THE DC OUTPUTS ARE TO BE DISABLED.

§ OVER POWER PROTECTION: AT 115/230 VAC INPUT THE POWER SUPPLY WILL SHUT DOWN

ALL DC OUTPUT WITH IN 105% TO 150% OF FULL LOAD.

§  OVER VOLTAGE PROTECTION: +5V  →  7.0V, +12V1,2,3,4  →  15.6V, +3.3V  → 4.3V.
§  DIMENSION: 220 (D) x 150 (W) x 86 (H) mm.
§  COOLING: ONE 80 mm DC FAN.
§  ACTIVE POWER FACTOR CORRECTION: EN 61000-3-2: 1995+A1+A2: 1998, CLASS D.

u OUTPUT CHARACTERISTICS:

OUTPUT CURRENT

REGULATION

OUTPUT

VOLTAGE

MIN

[A]

MAX

[A]

LOAD

LINE

RIPPLE

MAX

[P-P]

NOISE

MAX

[P-P]

+5V

1.5

±5%

±1%

50mV

+12V1

1.5

±5%

±1%

120mV

+12V2

1.5

±5%

±1%

120mV

+12V3

1.5

±5%

±1%

120mV

+12V4

1.5

±5%

±1%

120mV

+3.3V

0.5

±5%

±1%

50mV

-12V

0.8

±10%

±1%

120mV

+5VSB

4.0

±5%

±1%

50mV

1. MAXIMUM CONTINUOUS COMBINED LOAD ON +5V AND +3.3V OUTPUTS SHALL NOT EXCEED 200W.

+12V1, 2,3 AND +12V4 OUTPUTS SHALL NOT EXCEED 80A.

2. MAXIMUM CONTINUOUS COMBINED LOAD ON +5V, +3.3V AND +12V1, 2,3,4 OUTPUTS SHALL NOT

EXCEED 975 W.

3. MAXIMUM CONTINUOUS TOTAL DC OUTPUT POWER SHALL NOT EXCEED

1000W.