Epson perfection 2450 사용자 설명서

EPSON Perfection 2450 PHOTO

9/01

EPSON Perfection 2450 PHOTO - 3

Before scanning transparent documents, you need to remove 
the scanner’s reflective document mat; this exposes the scanner’s 
transparency unit (light source), which is built into the lid. 

If you’re scanning slides or film strips, you’ll also need to use 
one of the film holders.

To use the transparency unit, remove the reflective document 
mat by grasping the top of the mat and sliding it up gently, as 
shown. 

Make sure the cable for the tranparency unit is plugged into the 
round connector. If not, turn off the scanner, then connect the 
cable as shown. 

Film has two sides, a shiny base side and a dull emulsion side. 
The base side of the film has the film maker’s name and film ID 
numbers printed on it. Always place the shiny base side down.

To scan 35-mm film strips, 4 

× 5-inch film, or 120/220 (6 × 9-

cm) film, place the film in the correct holder, as shown:

Place the holder with the film onto the scanner. Make sure the 
white triangle on the holder points to the upper-right corner of 
the scanner.

remove mat

by sliding it up

transparency unit

35-mm strips

4 

× 5-inch film

120/220 (6 

× 9-cm)

 film