Epson emp 800 사용자 설명서

You can run a self test to determine whether the problem comes 
from the printer itself or the computer. 

◗

If the results are satisfactory, the problem lies in software 
settings, the interface cable, or your computer.

◗

If the self test does not print correctly, you have a problem 
with your printer. See the suggestions in this chapter for 
possible solutions.

Follow these steps to run the test:

1. Make sure both the printer and computer are turned off.

2. Disconnect the interface cable from the printer.

3. Make sure paper is loaded in the feeder.

4. Press the

 

E

 l

oad/eject button and hold it down while you 

press the

 

Ppower button. Continue to hold the buttons 

until the

 

Ppower light starts to flash.

The printer prints a nozzle check pattern (shown on 
page 5-8) and samples of fonts and colors. 

5. To end the test, turn off the printer.

You can use the printer’s hex dump mode to identify problems 
if you know how to interpret hex code. Or, you can fax the hex 
printout to a technical support representative. Follow these 
steps to use hex dump mode:

1. Make sure the printer is turned off and has paper in the 

feeder.

2. Open the cover.

easch6.fm5  Page 3  Tuesday, January 14, 1997  9:48 AM