Adam Equipment cbda 사용자 설명서

 

 

•  Level the scale by adjusting the four feet. The scale should be 

adjusted such that the bubble in the spirit level is in the centre of 
the level and the scale is supported by all four feet.  

 

 

 

•  Attach the power supply cable to the connector on the right side 

of the scale base. Plug in the power supply module. The power 
switch is located at the right side of the scale base. 

 

•  The scale will show the model number  in the “Weight” display 

window (CBDa 15- where 15 denotes the maximum capacity of 
the scale in Kg) and the current hardware and software revision 
numbers in the “Unit Weight” display window . 

 

(For example “

1.4-1 .11”:  The first number “1.4” is the hardware 

revision number of the main circuit board and the next one “

1 .11” 

is the software revision number).  
 

• 

Next a self-test is followed. At the end of the self-test, it will 
display “

0” in all three displays, if the zero condition has been 

achieved. 

 
 

•  The CBDa Series can be connected to any size of load cell type 

weighing base via the Remote scale port on the right side of the 
scale case. Ensure you have the correct base for the scale as 
each is matched for calibration.  

 

•  Place the remote scale platform in the position where it is to be 

used.  Level the scale by adjusting the four feet. If fitted with a 
spirit level then it should be adjusted such that the bubble is in 
the centre. 

 
• Press [Local/Rem] and test weighing performance.  

 

6