Epson 386 사용자 설명서
This means the operating system is ready for you to enter a
command. The command prompt identifies the current operating
drive: A, B, or C, for example. Usually, drive A is the top diskette
drive; B is the second diskette drive, C is the first hard disk drive, and
D is used for a second hard disk drive.
drive; B is the second diskette drive, C is the first hard disk drive, and
D is used for a second hard disk drive.
The command prompt appears on the screen whenever you load
MS-DOS, complete an MS-DOS command, or exit an application
program.
program.
10
Copying System Diskettes
Now that you have set up your system and loaded
MS-DOS, it is important that you make copies of your four system
diskettes right away. Use only the copies (usually called “working
diskettes right away. Use only the copies (usually called “working
copies”) for daily use and store the originals in a safe place.
To copy your system diskettes, you need four blank, 360KB, double-
sided, double-density, 5¼-inch diskettes. (Although you will probably
be using 1.2MB diskettes in your Equity 386, the system diskettes
have a capacity of 360KB. There ore, you must use 360KB diskettes to
f
make the copies.)
Follow these steps:
1. Remove the Startup diskette from the diskette drive by turning
the latch up and pulling out the diskette. Then insert the diskette
labelled “Operating 1 ” and turn the latch down to secure the
diskette. The Operating 1 diskette contains the DISKCOPY
labelled “Operating 1 ” and turn the latch down to secure the
diskette. The Operating 1 diskette contains the DISKCOPY
program which you will use to make the copies.
Setting Up Your System
1-15