TP-LINK TD-8816 사용자 설명서

 

18 

 

VCI: Identifies the virtual channel endpoints in an ATM network. The valid range is from 
32 to 65535 (1 to 31 is reserved for well-known protocols). Please input the value 
provided by your ISP. 

 

QoS: Select the Quality of Service types for this Virtual Circuit, including CBR (Constant 
Bit Rate), UBR (Unspecified Bit Rate) and VBR (Variable Bit Rate). These QoS types are 
all controlled by the parameters specified below, including PCR (Peak Cell Rate), SCR 
(Sustained Cell Rate) and MBS (Maximum Burst Size), please configure them according   
to your needs. 

There are two IP versions: IPv4 and IPv6. If you select IPv4 as IP version, please follow the 

configuration below to configure the parameters for WAN ports. 



  Encapsulation:  There are four connection types: Dynamic IP Address, Static IP Address, 

PPPoA/PPPoE and Bridge Mode. Please choose the designed type that you want to use. 
After that, you should follow the configuration below to proceed. 

Select this option if your ISP provides you an IP address automatically. This option is typically 

used for Cable services. Please enter the Dynamic IP information accordingly.   

 

Figure 4-7 



  Encapsulation: Select the encapsulation mode for the Dynamic IP Address, you can leave it 

default. 



  Bridge Interface: Activate the option, the modem router can also work in Bridge mode. 



  Default Route: If enable this function, the current PVC will be considered as the default 

gateway to Internet from this device.