Siemens gigaset s450 ip 사용자 설명서
94
Appendix
Gigaset S450 IP LBA / SGP / A31008-M1713-Y221-1-7619 / appendix.fm / 30.8.07
Ve
rs
ion 4,
16
.09.
2005
Appendix
Care
¤
Wipe down the base station and hand-
set with a damp cloth (no solvents) or
an antistatic cloth.
Never use a dry cloth. This can cause a
build up of static.
Contact with liquid
If the handset has come into contact with
liquid:
¤
Switch the handset off and remove
the batteries immediately.
¤
Allow the liquid to drain from the hand-
set.
¤
Pat all parts dry, then with the battery
compartment open and the keypad fac-
ing down place the handset in a dry,
warm place for at least 72 hours (not
in a microwave, oven etc.).
¤
Do not switch on the handset again
until it is completely dry.
When it has fully dried out, you will nor-
mally be able to use it again.
Questions and answers
If you have any questions about using
your phone, visit us at any time at
The table below contains a list of common
problems and possible solutions.
!
Please note:
To support the service team, it can be helpful if
you have the following information to hand:
– Version of firmware, EEPROM and your
– Version of firmware, EEPROM and your
phone's MAC address
You can check this information with the
You can check this information with the
Web configurator (page 93). For how to
display the MAC address on your handset,
turn to page 70.
– VoIP status code (page 97)
For problems with VoIP connections, you
should set VoIP status messages to be dis-
played on your handset. (page 69,
page 93). These messages contain a status
code that helps when the problem is ana-
lysed.
The display is blank.
1. The handset is not switched on.
1. The handset is not switched on.
¥
Press and hold the end call key
a
.
2. The battery is flat.
¥
Charge the battery or replace it
The keys of a handset do not respond when
pressed.
The key lock is activated.
The key lock is activated.
¥
Press and hold the hash key
#
Base "X"
flashes on the display.
1. The handset is outside the range of the
base station.
¥
Move the handset closer to the base
station.
2. The base station is not switched on.
¥
Check the base station's mains adapter
3. An update of the base station firmware is
currently being conducted (page 67/
¥
Please wait until the update is complete.