Siemens Gigaset S450 사용자 설명서
7
First Steps
Gigaset S450 / English for Greece / A31008-M1716-T101-1-8U19 / starting.fm / 07.09.2005
Placing the handset in the base station
and registering
¤
Place the handset in the base with its
display facing upwards.
display facing upwards.
The handset registers automatically.
Registration takes around 1 minute.
During this time
Registration takes around 1 minute.
During this time
Regstr.Procedure
appears
in the display and the name of the base
station flashes, e.g.
station flashes, e.g.
Base 1
. The handset
will be assigned the lowest unassigned
internal number (1–6).
This will appear in the display when
registration is complete, e.g.
internal number (1–6).
This will appear in the display when
registration is complete, e.g.
INT 1
. This
means that the number 1 has been
assigned. If the internal numbers 1–6 are
already assigned to other units, the
number 6 is overwritten.
assigned. If the internal numbers 1–6 are
already assigned to other units, the
number 6 is overwritten.
To charge the batteries, leave the handset
in the base station.
in the base station.
For questions and problems see page 44.
Headset socket
You can connect the following types of
headset (with jack connector): HAMA
Plantronics M40, MX100 and MX150.
headset (with jack connector): HAMA
Plantronics M40, MX100 and MX150.
Initial charging and discharging of
batteries
If the handset is activated, the flashing
battery icon
battery icon
e in the top right of the
display indicates that the batteries are
being charged.
During handset operation, the battery icon
indicates the charge status of the
batteries (page 1). The correct charge
level can only be displayed if the batteries
are first fully charged and discharged.
being charged.
During handset operation, the battery icon
indicates the charge status of the
batteries (page 1). The correct charge
level can only be displayed if the batteries
are first fully charged and discharged.
¤
To do this, leave the handset in the
base or charging cradle continuously
for ten hours. Your handset need not
be switched on for it to charge.
base or charging cradle continuously
for ten hours. Your handset need not
be switched on for it to charge.
¤
Afterwards, remove the handset from
the base station and do not put it back
again until the batteries are fully
discharged.
the base station and do not put it back
again until the batteries are fully
discharged.
Notes:
– Automatic registration is only possible
while no-one is making calls using the base
station.
station.
– Each key press interrupts the automatic
registration.
– If automatic registration does not work the
handset will have to be registered manually
(page 33).
(page 33).
– You can change the name of the handset
Notes:
– If the handset has switched itself off
because the batteries are flat and is then
placed in the base station, it will switch
itself on automatically.
placed in the base station, it will switch
itself on automatically.
– Only place the handset in the base or
charging cradle that is intended for it.
Note:
After the first battery charge and discharge
you may replace your handset in its base after
every call.
you may replace your handset in its base after
every call.