Epson EMP-100NL 사용자 설명서

88 - Cleaning the Projector, Cleaning the Lens, Cleaning the Air Filter

Clean the projector if it becomes soiled or if the quality of the projected images deteriorate. 
Please clean the air filter about every 100 hours of operation.

Switch off the power supply and disconnect the Power Cord prior to cleaning any part of the 
projector. 

· Gently wipe the soiled parts of the projector with a soft cloth. 
· When the soiling is severe, wipe the area with a cloth moistened with a medium-strenth 

cleaning agent diluted with water, and then gently wipe it with a dry cloth. 
Never use wax, Benzene, thinner or other active agents. Failure to observe this may result in 
damage or paint peeling from the casing.

Clean the lens with an air-blower (available on the open market) and special lens cleaning 
paper. The surface of the lense is easily damaged, so exercise extreme caution and avoid using 
anything other than soft materials.

Warning

· Personnel other than qualified servicemen must never open the projector. Many high-volt-

age parts are contained inside the cover that may cause electric shocks. Contact your dealer 
or your nearest adress provided at page 104 to request internal inspections, repairs, adjust-
ments, cleaning and other tasks.

· Exercise caution when handling the Power Plug and Power Connector. Mishandling may 

result in the outbreak of fire and electric shocks. Observe the following when handling the 
Power Plug.

· Do not connect plugs or connectors that have become dirty or have foreign matter adher-

ing to them.

· Ensure that the plugs and connectors are firmly inserted in the relevant sockets as far as 

they will go.

· Never attempt to connect plugs and connectors with wet hands.

Caution

· Never attempt to remove the lamp immediately after use.

Failure to observe this may result in burns or other injuries. Allow the projector to cool 
down for at least sixty minutes after the power supply has been switched off.

· Disconnect the Power Plug and Power Connector from their sockets when carrying out 

maintenance tasks. Failure to observe this may result in electric shocks.