Parker Hannifin mx80l precision grade 사용자 설명서
MX80L Series Product Manual
Chapter 1 - Introduction
Parker Hannifin Corporation
7
Specification Conditions
Specifications Are Temperature Dependent
Catalog specifications are obtained and measured at 20 Degrees C. Specifications at any other
temperature may deviate from catalog specifications. Minimum to maximum continuous operating
temperature range (with NO guarantee of any specification except motion) of a standard unit before
failure is 5 - 40 degrees C.
temperature may deviate from catalog specifications. Minimum to maximum continuous operating
temperature range (with NO guarantee of any specification except motion) of a standard unit before
failure is 5 - 40 degrees C.
Specifications Are Mounting Surface Dependent
Catalog specifications are obtained and measured when the positioner is fully supported, bolted
down, and is mounted to a work surface that has a maximum flatness error of:
down, and is mounted to a work surface that has a maximum flatness error of:
• Standard Grade: 0.003mm/300mm (0.0001”/ft)
• Precision Grade: 0.001mm/300mm (0.00004”/ft)
Table will operate with work surface 0.100mm/300mm but performance specifications will be
significantly effected.
significantly effected.
Specifications Are Point of Measurement Dependent
Catalog specifications and specifications in this manual are measured from the center of the carriage,
38 mm above the carriage surface. All measurements taken at any other location may deviate from
these values.
38 mm above the carriage surface. All measurements taken at any other location may deviate from
these values.
Daedal Division
Irwin, Pennsylvania
Irwin, Pennsylvania