Philips cdr796-05s 사용자 설명서
WARNING
Under no circumstances should you try to repair the set yourself as this
will invalidate the guarantee. Do not open the set as there is a risk of
electric shock.
will invalidate the guarantee. Do not open the set as there is a risk of
electric shock.
If a fault occurs, first check the points listed, before taking the set for
repair. If you are unable to solve a problem by following these hints,
consult your dealer or service centre.
repair. If you are unable to solve a problem by following these hints,
consult your dealer or service centre.
Laser safety
This unit employs a laser. Only a qualified service person should remove
the cover or attempt to service this device, due to possible eye injury.
the cover or attempt to service this device, due to possible eye injury.
Problem
Solution
No power
– Make sure the mains cable is connected properly.
– Press 2 STANDBY·ON on the set to switch it on.
– Press 2 STANDBY·ON on the set to switch it on.
No sound
– Check if the audio connections have been installed properly.
– Make sure MP3-tracks are recorded in the correct format.
– Make sure MP3-tracks are recorded in the correct format.
No reaction to controls
– Disconnect the set from power supply, reconnect after a few seconds.
Automatic start of permanent
– Keep Ç on the set pressed for at least 5 seconds to cancel the
feature display (demo mode)
demonstration mode.
Remote control does not function
– Remove batteries and insert them correctly or insert new batteries.
properly
– Reduce distance to the set.
WRONG DISC, USE AUDIO CD and
– Make sure the disc is not scratched or dirty. Replace or clean the disc.
INSERT DISC indication
– Make sure disc is inserted, printed side up.
– Make sure there is no DVD inserted.
– Wait until steamed up laser lens has cleared.
– Make sure there is no DVD inserted.
– Wait until steamed up laser lens has cleared.
WRONG DISC, USE CDR<W> WITH
– A computer CDR(W) is inserted. Make sure a digital audio disc is inserted
`
DIGITAL AUDIO´ LOGO and
marked with “Digital Audio” and the special logo.
INSERT DISC indication
NO SIGNAL indication or
NO SIGNAL indication or
– Check if the connection cable is properly connected.
CHECK INPUT indication
– Select the correct input.
– Make sure the external appliance is switched on.
– Make sure the external appliance is switched on.
OVERHEATING indication
– Do not position the set on top of other equipment that might heat it up
(e.g. receiver).
Does not record
– Make sure the CDR(W) is absolutely free of scratches and dust particles.
– Check if a digital audio CDR(W) is inserted and make sure it is unfinalized.
– Check if a digital audio CDR(W) is inserted and make sure it is unfinalized.
Stops during recording
– Use Philips audio CDR(W)s.
– In case recording process is interrupted (power loss, mechanical shock), start
– In case recording process is interrupted (power loss, mechanical shock), start
recording again with a new disc.
Recorded disc does not play in
– Make sure the CDR(W) is finalized.
another standard CD player
– Insert the CDRW in a CDRW compatible CD player.
Missing directories on MP3-CD
– Only albums with playable files will be shown.
Elapsed playing time of MP3-track
– That is normal behaviour as this MP3-track has a variable bit rate.
counts up very fast or irregularly
Recorded tracks have been merged
– Use another track increment mode.
together or tracks do not start
– Insert track increments manually with the remote control.
or stop at the correct time
Troubleshooting
21
English