Philips ct5688-000000eu 사용자 설명서

다운로드
페이지 69
Troubleshooting
57
Troubleshooting
The phone 
does not 
switch on
Remove/reinstall the battery (see
page 1). Then charge the phone
until the battery icon stops
scrolling. Unplug from charger and
try to switch the mobile on.
The display 
shows 
BLOCKED 
when you 
switch on
Somebody tried to use your phone
but didn’t know the PIN code nor
the unblocking code (PUK).
Contact your service provider.
The display 
shows IMSI 
failure
This problem is related to your
subscription. Contact your
operator.
Your phone 
doesn’t 
return to 
the idle 
screen
Press and hold 
)
 or switch off
the phone, check that the SIM card
and the battery are installed
correctly and switch it on again.
The  
symbol is 
not 
displayed
The network connection is lost.
Either you are in a radio shadow (in
a tunnel or between tall buildings)
or you are outside the network
coverage area. Try from another
place, try to reconnect to the
network (especially when abroad),
check that the antenna is in place if
your mobile has an external
antenna, or contact your network
operator for assistance/
information.
The display 
doesn’t 
respond (or 
the display 
responds 
slowly) to 
key presses
The display responds more slowly
at very low temperatures. This is
normal and does not affect the
operation of the phone. Take the
phone to a warmer place and try
again. In other cases please contact
your phone supplier.
Your 
battery 
seems to 
over heat
You might be using a charger that
was not intended for your phone.
Make sure you always use the
Philips authentic accessory shipped
with your phone.
Philips568_GB_4311 255 60731.book  Page 57  Mardi, 5. octobre 2004  3:24 15