Philips mc-90 사용자 설명서

30

3139 115 20972

Press 

TUNER to select TUNER mode.

➜ "

TUNER" is displayed.  A few seconds later, the

current radio frequency will appear on the
display.

Press 

TUNER again to select the desired

waveband : FM, MW or LW.

Press and hold à or á until the frequency
indication starts to change, then release.
➜ The display will show "

SEARCHING" until a

radio station with sufficient signal strength is
found.
➜ If an FM station is received in stereo,   will
appear on the display.

Repeat step 

3 if necessary until you find the

desired radio station.

● To tune to a weak station, press à or á briefly

and repeatedly until optimal reception found.

You can store up to 40 preset radio stations in
the memory.

● Plug and Play setting (refer to “Basic Functions -

Plug and Play”).
OR

Press 

TUNER to select TUNER mode.

● Adjust JOG CONTROL (or pressí or ë

on the remote control) to select the desired
preset number.
➜ If a radio station has been stored in one of
the presets, it will not be stored again under
another preset number.

Press and hold 

PROG until "

AUTOPROGRAM" is

displayed.
➜

 starts flashing.

➜ The system will automatically store the radio
stations with sufficient signal strength, starting
from all RDS stations and followed by FM, MW
and LW bands respectively.  Weak RDS stations
may be stored in later presets.
➜ When all the available radio stations are
stored or the memory for 40 presets are used,
the last preset radio station (or the first available
RDS station) will be played.

● Press PROG or Ç on the system.

ECO 
POWER

CDR OPEN•CLOSE

pg 001-038/MC90/22-Eng

1/29/02, 6:38 PM

30