Maytag w10441076c - sp 사용자 설명서

6

Cycle Status Lights

Delay
  If a Delay Start is set, the Delay indicator will light 

and the delay time will count down in the display. 

Door Locked
  Door Locked will light to indicate that the door  

is locked and cannot be opened without first  

pausing or canceling the cycle. 

Sensing
  When START is touched and held, the washer  

will first perform a self-test on the door lock  

mechanism and the sensing light will come on.  

You will hear a click, the drum will make a partial 

turn,  

and the door will unlock briefly before locking again. 

  Once the door has locked the second time, the washer will begin 

tumbling and adding water. This sensing process will continue 

throughout the cycle. You may also hear water flowing through  

the dispenser, adding detergent to the load. 

  After the load size is sensed, the estimated time based on load 

size will be displayed. The actual cycle time may be lengthened; 

however, the display will continue to show the estimated time. 

  The sensing light will blink once a second at various times during 

the cycle, such as when the washer is reducing extra suds.

Add a Garment
  When “Add a Garment” is lit, you may pause the washer,  

open the door, and add items. 

Steaming
  This will light to show that the cycle is using a steam boost  

for added cleaning power.  

Done
  Once the cycle is complete, this light will come on. Remove the 

load promptly for best results. 

 

The Done indicator is also lit during 

Fresh Hold

®

 or Fresh Spin

™

 option.

Adding HE detergent to dispenser

Powdered detergent:  

Lift the selector to the high 

position.

Liquid detergent:  

Push down the selector to the 

low position.

Pour a measured amount of HE  

detergent into detergent compartment.  

For powdered detergent, lift the selector 

to the high position. For liquid detergent, 

push down the selector to the low 

position.

Do not overfill; adding too much detergent may cause 

detergent to be dispensed into the washer too early. 
IMPORTANT: 

n

  Do not add single-dose laundry packet to dispenser drawer. 

n

  Use powdered detergent when using the Delay Start option. 

Liquid detergent may seep out before the wash begins.

HE detergent  

compartment

1.  Open the dispenser drawer.
2.  Add laundry products as described in steps 4–6 in the  

“Using Your Washer” section.

3.  Slowly close the dispenser drawer. Make sure it is  

completely closed.  

NOTE: A small amount of water may remain in the dispensers from 

the previous wash cycle. This is normal.

Selector

Selector 

in high 

position

Selector 

in low 

position