Hitachi VT-F372A 사용자 설명서
Getting Started (Initial Setup)
29
For convenience, the TV channel numbers should match those programmed into the
VCR. If your TV has automatic channel programming, set it on the same mode - ANT,
CATV1 or CATV2 - and let it reprogram to match the VCR.
Once channels are preset, you can use the up and down CHANNEL buttons to move
through the active channels. Or you can press the number buttons to move quickly
between channels that are far apart.
CATV1 or CATV2 - and let it reprogram to match the VCR.
Once channels are preset, you can use the up and down CHANNEL buttons to move
through the active channels. Or you can press the number buttons to move quickly
between channels that are far apart.
Removing Channels
You may not want to keep all the stations the auto-programmer selects, since you may
prefer to have only a few favorite channels in the tuner's memory. Or, you may want to
delete from memory a weak or unused channel that the tuner picked up.
You may not want to keep all the stations the auto-programmer selects, since you may
prefer to have only a few favorite channels in the tuner's memory. Or, you may want to
delete from memory a weak or unused channel that the tuner picked up.
Erased channels cannot be selected by the up and down CHANNEL buttons but can
still be selected by using the numbered buttons 0 to 9 and 100/ENT.
Adding Channels
Occasionally the auto-programming may skip an active channel because the antenna
was pointed in the wrong direction or the channel had a weak signal or was "off the air"
at the time of programming. Or you may change your mind about a channel you
removed from memory.
Occasionally the auto-programming may skip an active channel because the antenna
was pointed in the wrong direction or the channel had a weak signal or was "off the air"
at the time of programming. Or you may change your mind about a channel you
removed from memory.
To Add or Erase Channels
Press GUIDE, then press 5 to bring up the Initial Setup screen. Item 9 lets you add or
delete channels. Use the number buttons to enter the channel you want to change,
then press STOP to delete it or press PLAY to add it.
then press STOP to delete it or press PLAY to add it.
Caution After a Power Failure
If a power failure lasting for more than 30 minutes occurs, reset the clock and perform
the "AUTO CHANNEL SETTING" found in the "INITIAL SET-UP" menu.
If a power failure lasting for more than 30 minutes occurs, reset the clock and perform
the "AUTO CHANNEL SETTING" found in the "INITIAL SET-UP" menu.
Choosing a Mode for Audio Playback
Choose between hi-fi and linear modes, depending on your needs.
HIFI is the preferred setting because it works for all tapes whether they were recorded
in hi-fi or linear modes. If the audio sounds distorted or unusual or there is no audio, try
the LINEAR option.
When you set the option to HIFI, hi-fi tapes will play in high fidelity, and non-hi-fi tapes
will play in linear mode.
HIFI is the preferred setting because it works for all tapes whether they were recorded
in hi-fi or linear modes. If the audio sounds distorted or unusual or there is no audio, try
the LINEAR option.
When you set the option to HIFI, hi-fi tapes will play in high fidelity, and non-hi-fi tapes
will play in linear mode.
Stereo vs. Mono Sound
When you select the STEREO option, your VCR records in stereo any station that
broadcasts stereo sound. When a TV channel broadcasts in stereo, you'll see a stereo
indicator on the TV screen.
broadcasts stereo sound. When a TV channel broadcasts in stereo, you'll see a stereo
indicator on the TV screen.