Garmin 16 사용자 설명서

6

The following additional items are needed or optional 

to complete the installation of your GPS 16:

• Receiver mount— Since  mounting  

 

        locations and methods vary, you may need 
        to obtain a mount to install the GPS 16. 
        The  receiver base uses either our Magnetic 
        Mount or may be fl ush mounted.

• On/Off switch (optional)— Power to the 

        receiver may be controlled by an on/off switch, 
        such as an accessory switch on the control 
        console. Check with an electric supply retailer for 
        this item.

It is recommended that the system be temporarily 

hooked up with the wiring and the unit placed at the 
desired installation location. Then, check operation with 
potential interfering equipment turned on and off. (For 
example, other electronic equipment, fan motors, engine 
ignition, alternators, generators, radars and VHF radio 
transmissions can be sources of interference.)

Position the receiver so that the clearest possible view 

of the sky and horizon in all directions is obtained. Avoid 
mounting the receiver next to large areas of conductive 
material (metal, aluminum, etc.) as this may cause poor 
signal reception. The GPS 16 is supplied with a 17 foot 
(5 meter) power/data cable. When routing the wiring to 
the GPS 16, avoid routing the cable near an alternator 
or ignition system components or parallel to other power 
lines.

I

GPS16 QSG.indd

1/7/02, 4:07 PM

6