crimestopper-security-pro cs-2003dc 사용자 설명서

 

 

SIREN MOUNTING: Mount the siren under the hood to fender-well or other body surface with the open end facing 
downward.  Run the red siren wire through the firewall using a rubber grommet.  Ground the black wire to the body 
metal near the siren. 

 

LED: Mount the red LED in a visible location on the dashboard or console. 

 

Shock Sensor: Mount the included shock sensor with wire ties to an under dash wire harness or fasten with screws to 
firewall or side paneling. 

 

Override/Program Button: Mount the Override/Program push-button in a hidden but accessible location.  It is used 
for emergency disarm without the use of the transmitter and for programming certain features. 

 

 

Connect to a +12 Volt source or Chassis Ground depending on the output required for PIN 2 Gray wire See Below. 

 

Connect this wire to an AUX device or function.  This output will provide a momentary signal when button #3 is pressed 
on the remote control.  The (+/-) polarity of this output depends on the connection of PIN 1 Gray wire above. 

 

Connect to a +12 Volt source or Chassis Ground depending on the vehicles dome light circuit. (Required for PIN 4 
Black/White wire. See Below.) 

 

Connect this wire to the vehicle’s dome light circuit (May also be connected at the same point as the Door Pin Switch 
input).  This output will turn on the vehicle’s dome light when the system is disarmed using the remote control.  The +/- 
polarity of this output depends on the connection of the PIN 3 Black wire. 

 

Connect to a +12 Volt source with the supplied fuse and fuse-holder.  We recommend the connection to be at the 
Vehicle’s Battery Positive Terminal. 

 

Connect to the siren’s RED wire. 

 

Connect to Positive type door switches that show +12 Volts when the door is open and Ground when the doors are 
closed. (Many Ford vehicles.)