ZyXEL Communications P-660RU-T V2 사용자 설명서

 Chapter 3 Wizard Setup

P-660RU-T v2 User’s Guide

Figure 6   Internet Access Wizard Setup: First Screen

The following table describes the labels in this screen.

See 

 for background information on IP addresses and subnetting.

A static IP is a fixed IP that your ISP gives you. A dynamic IP is not fixed; the ISP assigns you 
a different one each time. The Single User Account feature can be enabled or disabled if you 
have either a dynamic or static IP. However the encapsulation method assigned influences 
your choices for IP address and ENET ENCAP gateway.

Table 4   Internet Access Wizard Setup: First Screen

Mode

From the Mode drop-down list box, select Routing (default) if your ISP allows 

multiple computers to share an Internet account. Otherwise select Bridge. 

Encapsulation

Select the encapsulation type your ISP uses from the Encapsulation drop-down list 

box. Choices vary depending on what you select in the Mode field.  
If you select Bridge in the Mode field, select either PPPoA or RFC 1483. 
If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET ENCAP or 

PPPoE.

Multiplex

Select the multiplexing method used by your ISP from the Multiplex drop-down list 

box either VC-based or LLC-based. 

Virtual Circuit 

ID

VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual circuit. 

Refer to the appendix for more information.

VPI

Enter the VPI assigned to you. This field may already be configured.

VCI

Enter the VCI assigned to you. This field may already be configured.

Next

Click this button to go to the next wizard screen. The next wizard screen you see 

depends on what protocol you chose above. Click on the protocol link to see the next 

wizard screen for that protocol.