Hitachi 42pd7500a 사용자 설명서
13
Connecting to an Audio Visual Device
(1) Make sure that the power switch of the monitor is turned off.
(2) Make sure that the power switch of the audio visual device is turned off.
(3) Use a commercially available cable and connector to connect the signal input terminal on the rear panel of this
(2) Make sure that the power switch of the audio visual device is turned off.
(3) Use a commercially available cable and connector to connect the signal input terminal on the rear panel of this
device and the signal output terminal of the audio visual device.
Monitor (rear panel)
Speaker (R)
Speaker (L)
Power
cord
cord
Antenna
3
C.1
C.2
C.2
COMMON INTERFACE
HDMI *
2
*
1
• AV1 SCART applies to composite/S-video, and AV2 SCART applies to composite/RGB.
• If a component input terminal and a composite input terminal of AV3 connect to the monitor at the same time, component input would govern.
• If video equipment with an S video output terminal is used, cabling by the S video cable is recommended to provide finer video quality.
• If a component input terminal and a composite input terminal of AV3 connect to the monitor at the same time, component input would govern.
• If video equipment with an S video output terminal is used, cabling by the S video cable is recommended to provide finer video quality.
(If an S video input terminal and a video input terminal of AV4 (side input) connect to the monitor at the same time, S video input would
govern.)
govern.)
• If the OUTPUT (Monitor) terminal is connected to an external monitor with a 75 Ohm terminal, it is possible to view the same image as on the
main unit. But it is possible to monitor only the composite video signal from AV1 ~ AV4 input that is displayed on the screen at the time.
• Whilst watching TV or DTT broadcasting, it is possible to switch between TV and DTT from AV1. At the time, SCART OUTPUT in Setup menu
need to be set to TV or DTT. Refer to .
• Secure connecting cables to the stand with the provided clamp.
Common Interface*
1
• Common interface allows you to receive Pay TV service with detachable modules.
• Inserting the common interface module:
• Inserting the common interface module:
1. Turn off the main power.
2. Insert the module all the way into the slot on the rear panel.
2. Insert the module all the way into the slot on the rear panel.
HDMI*
2
• HDMI (High-Definition Multimedia Interface) is a digital interface based on DVI (Digital Visual Interface), which is an added function for audio-
video equipment.
– It does not have degradation by transmission since it is digital.
– With only one cable, it is possible to transmit both picture signals and audio signals.
• In case of using analogue audio, when connecting with DVI-HDMI transformation connector, use analogue audio terminal for AV3 input.
– With only one cable, it is possible to transmit both picture signals and audio signals.
• In case of using analogue audio, when connecting with DVI-HDMI transformation connector, use analogue audio terminal for AV3 input.
[An example of connecting audio visual devices]
INSTALLATION INSTRUCTIONS (continued)
SCART Specification
CVBS
S-video
RGB
AV1
쑗
쑗
—
AV2
쑗
—
쑗
41