GTO pro-sl 51006100 사용자 설명서
2
Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS for the Installer
WARNING–To reduce the risk of injury or death:
I. Before Installation
1.
READ AND FOLLOW ALL INSTRUCTIONS.
2.
Verify this operator is proper for the type and size of gate, and its frequency of use.
3.
Make sure that the gate has been properly installed and slides freely in both directions. Repair or replace all
worn or damaged gate hardware prior to installation. A freely moving gate will require less force to operate
and will enhance the performance of the operator and the safety devices used with the system.
worn or damaged gate hardware prior to installation. A freely moving gate will require less force to operate
and will enhance the performance of the operator and the safety devices used with the system.
4.
All openings of a horizontal slide gate must be guarded or screened to prevent a 2
1
/
4
inch diameter sphere from
passing through openings anywhere in the gate. This screen (or guard) must also be installed over the portion
of adjacent fence that the gate covers in the open position (see page 5).
of adjacent fence that the gate covers in the open position (see page 5).
5.
Review the operation of the system and become familiar with its safety features. Understand how to disengage
and re-engage the operator with the foot pedal release (see GTO Pedal Release on page 1).
and re-engage the operator with the foot pedal release (see GTO Pedal Release on page 1).
6.
This gate operator is intended for vehicular gates ONLY. A separate entrance or gate must be installed for
pedestrian use (see page 5). NO ONE SHOULD CROSS THE PATH OF A MOVING GATE.
pedestrian use (see page 5). NO ONE SHOULD CROSS THE PATH OF A MOVING GATE.
II. During Installation
1.
Install the gate operator on the inside of the property and fence line. DO NOT install an operator on the outside
of the gate where the public has access to it.
of the gate where the public has access to it.
2.
Be careful with moving parts and avoid close proximity to areas where fingers or hands could be pinched.
3.
Determine the best obstruction sensing setting for this installation. The gate MUST stop and reverse on contact
with an obstruction or when an object activates the non-contact sensors. After adjusting the force or the limit
of travel, retest the gate operator. Failure to adjust and retest the gate operator properly can increase the
risk of injury or death.
with an obstruction or when an object activates the non-contact sensors. After adjusting the force or the limit
of travel, retest the gate operator. Failure to adjust and retest the gate operator properly can increase the
risk of injury or death.
4.
Additional safety equipment such as roller guards and safety edges (or photoelectric sensors) MUST
be installed to prevent bodily injury (see page 9).
be installed to prevent bodily injury (see page 9).
5.
Mount access controls away from the gate (minimum distance is 10 feet). The user must have full view of
the gate but be unable to touch it while operating the controls.
the gate but be unable to touch it while operating the controls.
6.
Secure outdoor or easily accessed gate operator controls in order to prohibit unauthorized use of the gate.
III. After Installation
1.
Review ALL safety instructions with the consumer/end user and explain the basic operation and safety
systems of the entire gate operator system, including operation of the foot pedal release.
systems of the entire gate operator system, including operation of the foot pedal release.
2.
Inform the consumer/end user that servicing of the operator must only be done by an experienced technician.
3.
Attach the warning signs (included) to each side of the gate to alert public of automatic gate operation. Take
a photo of warning signs installed on gate. Record the date of the photo for your reference.
a photo of warning signs installed on gate. Record the date of the photo for your reference.
4.
SAVE THESE INSTRUCTIONS
. Leave IMPORTANT SAFETY INSTRUCTIONS
(included) with consumer/end user.