Gianni Industries DG-30 사용자 설명서

Followed

「

03」：This will set the system to be used as : Slots 001~150 for PIN

codes only

Note:

When system format has the change, there’s a possibility the card stored would be

invalid. Please reset the system and input all cards /tokens.

Add card and deletion

Enter the Programming mode, Enter the slot position code 「001~100」

Green

light comes on:

This slot position is ready to register the card

Present card in front of the readerÆYellow LED blinks (beep) Æ enrolled
completed Æ（repeat）

Present card in front of the readerÆ (3 audible beeps) another card has already
been input (duplicate card).

Red

light comes on:

This slot already has a code registered

1. Press「＊＊」(deletion) Æ Green light Æ Enter the slot position code again

Present the card in front of the reader Æ﹝same as Step “A”﹞

Enter another slot card position

Add PIN codes and deletion

Enter the Programming mode, Enter the slot position code 「101~150」

Green

light comes on:

This slot position code may register the PIN codes

Input 5 digit PIN codes ÆYellow LED blinks (beep) Æ enrolled Æ（repeat）

Red

light comes on:

This slot position code is registered

1. Press「＊＊」(deletion) Æ Green light Æ Press the slot position code again Æ

Input 5 digit PIN codes Æ﹝same as Step “A”﹞

2. Enter another slot card position

Note 1:

The codes"12345" or master code are not be used for PIN code.

Note 2:

PIN codes operate open door：「???????????＊＊＊＊＊＃」

「

???….」random codes,「＊＊＊＊＊」5 digit PIN codes,「＃」Enter

To Program Relocking Timer

Enter the Programming mode,

A. Relay

1：Press「＊10」Followed by the number of seconds the relay should

open→「05」=5 seconds（01 ~99 = seconds）→（beep）→enrolled → Press
「

#」 to exit from the programming mode, or program other operating.

B. Enter「00」Sets the relay to latching mode.

(Correct code entered opens the relay,

and the relay stays open until the correct code is entered again).

C. Relay

2：Press「＊20」Followed by the number of seconds the relay should

open）→「05 =5 seconds (01 ~99 = seconds). →（beep）→enrolled → Press
「

#」 to exit from the programming mode, or program other operating.

D. Enter「00」Sets the relay to latching mode.

(Correct code entered opens the relay,

and the relay stays open until the correct code is entered again).

Changing the Master codes:

Enter the Programming mode, Enter「＊00」Followed by the new 5 digit master

code→（beep）→enrolled→Enter 「#」 to exit from the programming mode, or
program other operating.