Hitachi VT-FX623A 사용자 설명서

 

50

to record with the VCR Plus+ system you need to assign your local broadcast and cable 
channel numbers to the VCR Plus+ channel codes already stored in your VCR's 
memory. This is called channel setup and you do it using the on-screen Easy Guide 
System and the following step-by-step instructions. Then you will be ready to begin 
VCR Plus+ recording, also using the on-screen Easy Guide System. 
VCR Plus+ and PlusCode are trademarks of Gemstar Development corp. 

Before you begin 
1 Look for a listing like this one in your local TV program guide or Sunday newspaper 
TV section. Notice the small numbers to the right of the station name. 
These are the VCR Plus+ channel numbers that you will use in the channel setup 
procedure. 

 

2 Make a list of the VCR Plus+ channel numbers and the channel numbers you are 
receiving them on. If there are any difference, YOUR channel numbers must be 
assigned to the corresponding VCR Plus+ number. (See Example) 

 

Note in the example that the channel numbers are the same except for 20 (received on 
channel 8) and 42 (received on channel 38). These two channels must be assigned. 

This setup should be performed if you are using an Antenna or Cable without a cable 
box. (Hookups [A], [B], [C] or [D].) If you receive all your channels through a cable box 
(Hookups [E], [F] or [G]) please refer to page 26 "cable box setup" in "First Time Setup" 
section.