Garmin eTrex Vista 사용자 설명서

Installing the Batteries

The eTrex Vista operates on two “AA” batteries (not

included), which are located in the back of the unit.
Rechargeable Alkaline, NiMH, NiCad or Lithium batteries
may also be used.

Battery Cover

D-ring

Battery Compartment

Important Note:

When replacing batteries, use

only new or fully recharged

batteries and do not mix

Alkaline, NiMH, NiCad or

Lithium batteries.

Rechargeable batteries may

typically display less capacity

than Alkaline batteries.

Remove the batteries from the

unit if you don’t plan to use it

for several months.

Follow the battery manufactur-

er’s instructions for proper care

and disposal of used batteries.

When using ‘Battery Saver’ or

‘Use With GPS Off’ mode when
not navigating, Alkaline batter-

ies can last up to 12 hours.

Battery

Installation and

Backlight/Contrast

Getting Started

To install batteries:

1. Remove the battery cover on

the back of the unit. Turn the
D-ring 1/4 turn counter-clock-
wise & pull away clockwise.

2. Insert batteries

observing the
polarity.

3. Reinstall the

battery cover
by turning the
D-ring 1/4
turn.

Stored data is not lost when

the batteries are removed.

Press & Release POWER

Button to turn Backlighting

On/Off

Display Backlighting and Contrast Set Up

If lighting conditions make it hard for you to see the

display screen, you can adjust the contrast or turn on the
backlight.

To turn on the backlighting:

1. Press the POWER button to turn on the backlight

from any page on the unit. The backlight remains
on until the set timeout period is completed or the
POWER button is pressed again.

The unit is factory set to timeout 15 seconds after

the last button press. (To reset the backlight time-
out, refer to page 51.)

To adjust the screen contrast:

1. When on the Satelllie Page, use the ZOOM IN or

OUT buttons to adjust the contrast.

Use ZOOM IN & OUT

Buttons to Adjust Contrast

190-00219-00_0C.indd 3

9/20/2002, 9:54:13 AM