GE 2-9763 사용자 설명서

Signal

Meaning

One beep every 7 seconds

Battery is low

Three long beeps (with ringer on)

Page signal.

A long warbling tone (with ringer on)

Signals an incoming call.

One long beep

Handset and Base are
not communicating: the handset
might be too far away from the base,
you might need to try another
channel, or the base might not be
receiving power.

A brief warbling tone

You've stored a number in memory
successfully.

In case of difficulty, please check the following Troubleshooting Guide
before seeking service.

Problem

Solution

No dial tone

• Check installation:

— Is the base power cord connected to a working

outlet?

— Is the Phone-in-Use light on?
— Is the telephone line cord connected to the wall

jack?

• Disconnect the base from the wall jack and connect

another phone to the same jack. If there is no dial tone
in the second phone, the problem might be your
wiring or local service.

• Is the handset out of range of the base?
• Make sure the battery is properly charged (12 hours).
• Is the battery pack installed correctly? See page 12.
• Did the handset beep when you pressed the phone

button? Did the Phone-in-Use light come on? The
battery may need to be charged.

• Reset the security code by placing the handset in the

base for about 20 seconds.