Moog mf105b 사용자 설명서
The pedal cable should be shielded, with the shield connected to
the sleeve terminal. See Figure 14.
When connecting one or more pedal control input jacks to a
source of external control voltage such as an analog synth or a
MIDI-to-CV converter, you should use patch cords with tip-ring-
sleeve phone plugs. The ring terminal on the plug should not be
connected to anything, so that the MF-105B’s source of +5 volts
the sleeve terminal. See Figure 14.
When connecting one or more pedal control input jacks to a
source of external control voltage such as an analog synth or a
MIDI-to-CV converter, you should use patch cords with tip-ring-
sleeve phone plugs. The ring terminal on the plug should not be
connected to anything, so that the MF-105B’s source of +5 volts
Figure 14 – Correct wiring for an expression
pedal
An expression pedal for
use with the MF-105B
should contain a 50KW
or 100KW potentiometer
which is connected from the
sleeve to the ring terminals.
The potentiometer wiper is
connected to the tip terminal.
use with the MF-105B
should contain a 50KW
or 100KW potentiometer
which is connected from the
sleeve to the ring terminals.
The potentiometer wiper is
connected to the tip terminal.
Figure 15 – Correct wiring for a TRS CV
patch
is not shorted out. Or, if you do
not plan to use any expression
pedals with your MF-105B
but would like to apply control
voltages to one or more pedal
control inputs, you can use
patch cords with regular two-
conductor phone plugs. These
will short out the +5 volt supply to the ring contacts. This voltage
is current-limited, so you won’t burn anything out, - but no pedal
will work in any of the pedal control jacks if a tip-sleeve plug is
plugged into even one of the pedal jacks.
Applying a varying voltage to the tip terminal of a pedal control
input jack has the same effect as turning the corresponding knob. A
voltage change of about 5 volts at the tip terminal is equivalent to
turning the corresponding knob through its entire range. You can
‘program’ your MF-105B performance parameters entirely from
external control voltages, by turning the ENVELOPE, MIX, and
RATE control knobs to 5, and feeding 0 to +5 Volt programming
voltages to the tips of the pedal control input jacks. The LFO/
SWEEP jack can also receive 0 to +5 Volt programming voltages.
not plan to use any expression
pedals with your MF-105B
but would like to apply control
voltages to one or more pedal
control inputs, you can use
patch cords with regular two-
conductor phone plugs. These
will short out the +5 volt supply to the ring contacts. This voltage
is current-limited, so you won’t burn anything out, - but no pedal
will work in any of the pedal control jacks if a tip-sleeve plug is
plugged into even one of the pedal jacks.
Applying a varying voltage to the tip terminal of a pedal control
input jack has the same effect as turning the corresponding knob. A
voltage change of about 5 volts at the tip terminal is equivalent to
turning the corresponding knob through its entire range. You can
‘program’ your MF-105B performance parameters entirely from
external control voltages, by turning the ENVELOPE, MIX, and
RATE control knobs to 5, and feeding 0 to +5 Volt programming
voltages to the tips of the pedal control input jacks. The LFO/
SWEEP jack can also receive 0 to +5 Volt programming voltages.