omnitron-systems-technolo iconverter gx-tm 사용자 설명서
2.0
PORT STRUCTURE
2.1
OVERVIEW
The front panel of the GX/TM provides access to the management (serial console), UTP and fiber ports.
The fiber port will vary depending on the connector type; ST, SC, MT-RJ, LC or SFP supporting
1000BASE-FX transceivers. The plug-in module features two additional Ethernet ports for connectivity
via the chassis backplane.
The fiber port will vary depending on the connector type; ST, SC, MT-RJ, LC or SFP supporting
1000BASE-FX transceivers. The plug-in module features two additional Ethernet ports for connectivity
via the chassis backplane.
2.1.1
Management Port
PI
SA
The GX/TM features a Serial RS-232 Console Port (aka Craft Interface) which can be connected to a
computer for initial setup and configuration. The Serial Console Port is accessed through the mini DIN-6
female DCE interface. Connect the interface to a computer’s DB-9 serial port using the mini DIN-6 male
to DB-9 female cable adapter (Part # 8082-0), which is included with the GX/TM.
computer for initial setup and configuration. The Serial Console Port is accessed through the mini DIN-6
female DCE interface. Connect the interface to a computer’s DB-9 serial port using the mini DIN-6 male
to DB-9 female cable adapter (Part # 8082-0), which is included with the GX/TM.
An optional DB-9 male to female straight-through serial cable is available for extension (Part # 8081-3).
2.1.2
UTP and Fiber Ports
PI
SA
The UTP Ethernet port supports 10BASE-T, 100BASE-TX and 1000BASE-T protocols, auto-negotiation
and manual forced modes for half and full duplex. The UTP port can be enabled or disabled via network
management. A port disabled with the Port Access Control feature will still connect and allow 802.3ah
OAM or IP-less (secure) OAM communication, but blocks normal data traffic.
and manual forced modes for half and full duplex. The UTP port can be enabled or disabled via network
management. A port disabled with the Port Access Control feature will still connect and allow 802.3ah
OAM or IP-less (secure) OAM communication, but blocks normal data traffic.
The fiber interface supports the 1000BASE-X protocol. The fiber interface operates in manual mode or
auto-negotiation and supports full duplex operation. The fiber port can be enabled or disabled via network
management. A port disabled with the Port Access Control feature will still connect and allow 802.3ah
OAM or IP-less (secure) OAM communication, but blocks normal data traffic.
auto-negotiation and supports full duplex operation. The fiber port can be enabled or disabled via network
management. A port disabled with the Port Access Control feature will still connect and allow 802.3ah
OAM or IP-less (secure) OAM communication, but blocks normal data traffic.
2.1.3
Backplane Ethernet Ports
PI
The plug-in module supports two additional 100Mbps Ethernet Backplane Ports. The Backplane Ports A
and B allow Ethernet data connectivity between adjacent modules in an iConverter chassis. The two
backplane ports can be disabled or enabled via a DIP-switch or network management.
and B allow Ethernet data connectivity between adjacent modules in an iConverter chassis. The two
backplane ports can be disabled or enabled via a DIP-switch or network management.
The iConverter 19-Module, 5-Module, 2-Module and 1-Module Redundant Chassis backplanes provide
ethernet data connectivity between adjacent slots or ports. The A and B backplane ports connect the slots
as illustrated.
ethernet data connectivity between adjacent slots or ports. The A and B backplane ports connect the slots
as illustrated.
Page 4