Haier l32a9 사용자 설명서

다운로드
페이지 32
7
Preparation of remote control
  Installation of remote control batteries
•• As shown in the following diagram, put the remote control upside down and push open the 
battery chamber.
•• Insert 2 AAA batteries as shown in the following diagram.(The positive and negative poles 
must correspond to the indication).
•• Put back the battery chamber cover in place. 
3
1
2
Never use rechargeable batteries, such as nickel-cadmium batteries.Such 
batteries are different in shape and performance, proper operation is therefore 
hard to be ensured.
Please properly dispose the waste batteries in a environmentally friendly way.
Precautions for the use of batteries: 
Improper use of batteries may cause battery leakage, which may corrode the remote control 
or cause battery explosion.The following precautions must be obeyed: 
••Always replace batteries in pairs, i.e. replace a pair of old batteries with a pair of new 
ones. 
••Never use a new batteries together with an old one.
••Never use batteries of different types together, e.g. use a "zinc carbonate" battery together 
with an "alkaline" battery. 
••Never recharge, short circuit, reassemble, heat or burn used batteries.
••It is necessary to change batteries only when the remote control operates well or bad 
occasionally or fails to control the operation of the TV set. 
••If you don't use the remote control for a long period, take the batteries out of the remote 
control so as not to cause battery leakage thus damaging the remote control.
  Precautions while using remote control
Ensure no other objects are between the remote 
control and the remote receiver of the TV set. 
The remote control can not be kept in hot or 
humid environment, otherwise violent impact 
may cause the remote control failure.
Sunlight or other strong light may interfere 
the signal sent by the remote control.In this 
case, please turn the TV set towards the other 
direction. 
Use two AAA (7#) 1.5V alkaline batteries. Do 
not use different types of batteries together.
Mount the batteries as per correct polarity.