Uniden UBCT9 사용자 설명서

5.   To scroll repeatedly, press and hold   or   and

 

After 3 seconds, the scanner will begin to scan

 

through the Police frequencies (Police only).

6.   If you want to start scanning immediately, press
 

HOLD/RESUME.

1.   When scanning stops on a desired frequency, press
 

HOLD/RESUME to hold at that frequency as long 

 

as you like.

 

While ”HOLD” appears in this mode, you can 

 

use   or    to move up or down the frequency steps.

 

During Hold mode, you can see all frequencies

 

sequentially. It does not depend on your selected

 

bank.

 

Pressing and holding the keys for 1 sec, speeds up

 

frequency change.

 

If present frequency is locked out, then ”L/O” appears

 

on LCD.

2. To resume scanning, press HOLD/RESUME.

You can quickly store any frequency you find during scan.
1.   During scan, press HOLD/RESUME to store.
 

You can press   or    to move up or down 1 frequency step.

2.   If you have found the frequency you want to store, press E.

 

- Or- 

 

When the scanner stops on the frequency you want to store, press E.

3.   Select the private bank where you want to store the frequency, the smallest empty
 

channel number and “000.0000” flashes on and off over the frequency you want to  

 

store. Press E  (if the frequency you want to store exists already in a bank, you will hear  

 

an error tone and the other channel displays. Press E again to store the frequency in    

 

both channels).

To skip a frequency, press L/O. You can program up to 100 skip frequencies.
You can skip the frequencies in the scanning sequence.
If you change the state code, skipped frequencies are cancelled as soon as scanning 
starts. If you change the State, skip frequencies are all clear.

UBCT9 OM   16

12/11/07   3:53:34 PM