Uniden wxi3077 사용자 설명서

This device complies with part 1 of the FCC rules. Operation is subject 

to the following two conditions: (1) This device may not cause harmful 

interference, and (2) This device must accept any interference received, 

including interference that may cause undesired operation. Privacy of 

communications may not be ensured when using this phone. 

FCC PART 15.105(b): Note: This equipment has been tested and found to 

comply with the limits for a Class B digital device, pursuant to part 1 of 

the FCC Rules. These limits are designed to provide reasonable protection 

against harmful interference in a residential installation. This equipment 

generates, uses and can radiate radio frequency energy and, if not installed 

and used in accordance with the instructions, may cause harmful interfer-

ence to radio communications. However, there is no guarantee that inter-

ference will not occur in a particular installation. If this equipment does 

cause harmful interference to radio or television reception, which can be 

determined by turning the equipment off and on, the user is encouraged to 

try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver. 

Connect the equipment into an outlet on a circuit different from that to which 

the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

This product complies with FCC radiation exposure limits under the fol-

lowing conditions: 

The base must be placed to allow a minimum of 20 cm ( inches) between 

the antenna and all persons during normal operation. 

The base must not be collocated or operated in conjunction with any other 

antenna or transmitter. 

The handset is designed for body-worn operation and meets FCC RF 

exposure guidelines when used with any belt clip, carrying case, or other 

accessory supplied with this product. (All necessary accessories are included 

in the package; any additional or optional accessories are not required for 

compliance with the guidelines.) Third party accessories (unless approved by 

the manufacturer) should be avoided as these might not comply with FCC RF 

exposure guidelines. 

•

•

•

•

•

•

•

NOTICE: This equipment meets the applicable Industry Canada Terminal

Industry Canada Terminal 

Equipment Technical Specifications. This is confirmed by the registration 

number. The abbreviation IC before the registration number signifies that 

registration was performed based on a Declaration of Conformity indicat-

ing that Industry Canada technical specifications were met. It does not 

imply that Industry Canada approved the equipment.

NOTICE: The Ringer Equivalence Number (REN) for this terminal 

equipment is marked on the equipment itself. The REN assigned to each 

terminal equipment provides an indication of the maximum number of 

terminals allowed to be connected to a telephone interface. The termina-

tion on an interface may consist of any combination of devices subject only 

to the requirement that the sum of the Ringer Equivalence Numbers of all 

the devices does not exceed .
Radio equipment

The term IC before the radio certification number only signifies that Indus-

try Canada technical specifications were met. Operation is subject to the 

following two conditions: (1) this device may not cause interference, and 

(2) this device must accept any interference, including interference that 

may cause undesired operation of the device. "Privacy of communications 

may not be ensured when using this telephone".

WARRANTOR: UNIDEN AMERICA CORPORATION ("Uniden") 

ELEMENTS OF WARRANTY: Uniden warrants, for one year, to the original 

retail owner, this Uniden Product to be free from defects in materials and 

craftsmanship with only the limitations or exclusions set out below. 

WARRANTY DURATION: This warranty to the original user shall terminate 

and be of no further effect 12 months after the date of original retail sale. 

The warranty is invalid if the Product is (A) damaged or not maintained 

as reasonable or necessary, (B) modified, altered, or used as part of any 

conversion kits, subassemblies, or any configurations not sold by Uniden, 

(C) improperly installed, (D) serviced or repaired by someone other than 

an authorized Uniden service center for a defect or malfunction covered