Uniden BC250D 사용자 설명서

80

You can communicate and program your BC250D in
numerous ways with peripheral devices using the Remote
Interface Cable port. This radio offers the following modes:

❖ PC Control Mode

Program and control your scanner from a PC using
Uniden’s E-Scanner software.

❖ Clone Mode

Clone all the frequencies, trunking talkgroups, and fleet
maps programmed into your scanner to another BC250D
scanner or BC785D.

Plug the smaller end of the supplied Remote Interface Cable
into the remote port in accordance with the direction of the 
mark which is on the right side of the scanner. Plug the other
end of the cable (DB-9 serial connector) into a personal
computer’s serial port. A few PC’s may require an adapter,
most will not. Of course, make sure your PC is turned ON.

You can program and control your scanner remotely from 
a PC using Uniden’s E-Scanner software.

After connecting the scanner to a PC, turn the scanner ON.

To use the Remote (PC Control) mode, you must install
Uniden’s E-Scanner software and use as directed. Make sure
that your scanner is connected to the serial port of the PC
using the Remote Interface Cable.

BC250D  11/6/2 11:37 AM  Page 80