Uniden bct7 사용자 설명서

When you turn the

BCT7

off and then on again, the

BCT7

will return

to the last settings that were active.  When you have chosen the state
you will be driving in, and the mode (HIGHWAY PATROL, DOT, etc.),
the

BCT7

always returns to these settings.

Each state preprogrammed in the

BCT7

contains a number of Priority

channels. The

BCT7

automatically checks a state’s Priority channels

every two seconds for activity.  If there is activity on one of the Priority
channels, the warning light will flash and the alarm tone will sound
(see “Warning Alert,” page 11).
You will experience a slight in the conversations you hear as the

BCT7

checks the Priority channels. You can cancel the priority check

and the interruptions in the conversations by pressing the

H

key to

hold on the frequency.

The Warning Alert is inoperative while the scanner is on Hold.

Remember to press the key again to return to normal priority-scan
operation.
Priority cannot be changed, but you can lock-out priority channels
using the

L

key. Priority channels have been pre-determined by

the manufacturer as those Highway Patrol frequencies most
commonly used for mobile extenders and for car-to-car and
aircraft-to-car operations.  Mobile extenders re-transmit every radio
broadcast received on the patrol car radio to the officer’s walkie-talkie
at low-power.  Every time any officer or dispatcher talks (transmits),
the signal is broadcast like a beacon at  low-power whether or not the
officer is out of the car.

13