Dodge 2007 sprinter 사용자 설명서

You can disconnect the current to all your 
vehicle’s consumers using the battery 
isolating switch. This will prevent uncon-
trolled battery discharge caused by quies-
cent current consumption.

The battery isolating switch is to the right 
of the accelerator pedal in the driver’s foot-
well.

1 Connector
2 Slide

 Take the key out of the ignition lock 

and wait for approx. 20 seconds.

 Move red slide 2 down in the direc-

tion of the arrow and disconnect 
connector 1 from the ground pin.

 Clamp connector 1 under the acceler-

ator pedal so that it cannot make con-
tact with the ground pin.

The consumers of the vehicle battery 
are cut off from the electrical circuit.

G

If the vehicle is equipped with an auxiliary 
battery in the engine compartment, it is nec-
essary to disconnect both batteries when 
working on the vehicle electrical system. 
Only then is the electrical system fully dis-
connected from the power supply.

i

Only disconnect the vehicle electrical 
system from the power supply using 
the battery isolating switch if the vehi-
cle is to be parked up for a long period 
or when this is absolutely necessary.
After the power supply is switched on, 
you must reset the electric sliding door 
(

!

CAUTION

Make sure that the key is in position 0 
in the ignition lock and wait at least 
20 seconds before disconnecting or 
connecting the battery isolating 
switch. You could otherwise damage 
electrical system components.

!

CAUTION

When you clamp the connector under 
the accelerator pedal, make sure that 
the connector does not become:
 dirty
 damaged
It may otherwise not be possible to re-
store the electrical connection when 
the parts are reassembled.