Dodge 2007 sprinter 사용자 설명서

 Assemble the three-part pump lever for 

the jack.

 

1 Pressure release screw
 Close pressure release screw 1.
 To do this, turn the flattened section on 

the pump lever clockwise to the stop.

 Insert the pump lever into the recess 

on the jack and secure it by turning it 

clockwise.

 Make sure that the jack is positioned 

vertically under the jacking points de-

scribed below.

 Raise the vehicle by pumping the lever 

until the wheel is raised clear of the 

ground.
Make sure that the distance between 
the underside of the tires and the 
ground does not exceed 1.2 in (3 cm).

The vehicle jacking point is located under 

the longitudinal member in front of the 

front axle.

 

The vehicle jacking point is located under 

the longitudinal member in front of the rear 

axle.

 

i

Never turn pressure release screw 1 

more than 1 or 2 full turns. Hydraulic 

fluid could otherwise escape.

P58.10-2053-31

N40.10-2260-31

N40.10-2161-31