Clarion TB851P 사용자 설명서
280-8212-00
TB851P/TB853W
25
English
7.
CAUTIONS ON WIRING
1. Be sure to turn the power off before wiring.
2. Be particularly careful where you route the
wires.
Keep them well away from the engine, and
exhaust pipe, etc. Heat may damage the
wires.
exhaust pipe, etc. Heat may damage the
wires.
3. If the fuse should blow, check to see if the
wiring is correct.
If it is correct, replace the fuse with a new
one with the same amperage rating as the
original (15A FUSE).
one with the same amperage rating as the
original (15A FUSE).
4. To replace the fuse, remove the old fuse of
the power supply lead and insert the new
one. (Figure10)
one. (Figure10)
After connecting, secure the lead with a clamp
or insulation tape for protection.
or insulation tape for protection.
CAUTION
Figure 10
1. After the rear of the main unit has been
secured by the method shown in Figure 6
unfasten the special screw.
unfasten the special screw.
2. Remove the outer escutcheon.
3. Insert the hook plate between the spring and
the universal mounting bracket, fit tab B of
the spring into hole A of the hook plate, then
the spring into hole A of the hook plate, then
6.
REMOVING THE MAIN UNIT
pull the main unit out by the hook plate.
(Insert both the right and left edges of the
hook plate.) (Figure 9)
(Insert both the right and left edges of the
hook plate.) (Figure 9)
Note: Do not dispose of the hook plate. You cannot
remove the main unit without disengaging
the hook plate.
the hook plate.
Universal mounting bracket
2-Hook plate
Outer escutcheon
Instrument panel
Spring
Main
Unit
Unit
A
B
Figure 9
Fuse (15A FUSE)
Fuse holder
Note: There are various types of fuse holders. Do
not let the battery side touch other metal
parts.
parts.
*TB851P/TB853W(21-28)E
05.2.25, 11:27 AM
25