Clarion TB851P 사용자 설명서
280-8212-00
TB851P/TB853W
9
English
5. OPERATION
Basic Operation
Note: Be sure to read this chapter referring to the front diagrams in
chapter “3. CONTROLS” on page 5 (unfold).
Opening and adjusting the LCD
panel
panel
WARNING
• To prevent the battery from going dead,
operate this unit with the engine running
if possible.
if possible.
• When the LCD panel is operating, be
careful not to get your hands or finger
caught between the panel and main unit
or the vehicle instrument panel.
caught between the panel and main unit
or the vehicle instrument panel.
• Do not move the LCD panel by hand.
Raising the LCD panel
1. Press the [OPEN] button. The LCD panel
then ejects and rises automatically.
∗ While the LCD panel is opening or closing, the
blue LED of the [OPEN] button will flash.
Notes:
• If the LCD panel stops in the middle of this
• If the LCD panel stops in the middle of this
operation, press the [OPEN] button to house the
panel and then press the button again to stand it
up. The unit will be in the same display mode as
when last turned off.
panel and then press the button again to stand it
up. The unit will be in the same display mode as
when last turned off.
Panel calibration function
The LCD panel’s maximum angle of tilt can be
adjusted to match the installation configuration
within the automobile.
adjusted to match the installation configuration
within the automobile.
• Perform this with the LCD panel closed.
1. Press and hold the [OPEN] button for 5
seconds or longer, until the electronic beep is
heard.
heard.
2. The beep will sound twice, the panel will rise
and the calibration function will begin.
3. After completion of calibration, the panel will
close automatically.
∗ If the panel does not strike the instrument
panel or other parts of the car during
calibration, then the maximum tilt is 110°.
calibration, then the maximum tilt is 110°.
∗ If the panel comes in contact or strikes a car
part during calibration in a range of 70° then
the maximum downward tilt is 70°.
the maximum downward tilt is 70°.
Adjusting the angle, etc. of the LCD
panel
panel
The angle of the LCD panel or amount the panel
protrudes from the mounting surface can be
adjusted depending on the mounting angle of
the unit or light coming into the vehicle.
● To adjust the angle
1. Every time the [TILT] button is pressed, the
protrudes from the mounting surface can be
adjusted depending on the mounting angle of
the unit or light coming into the vehicle.
● To adjust the angle
1. Every time the [TILT] button is pressed, the
LCD panel tilts forward or backward at up to
about 20 degrees. The adjusted angel is
stored in the memory.
about 20 degrees. The adjusted angel is
stored in the memory.
Note:
• Do not move the LCD panel by hand.
• Do not move the LCD panel by hand.
*TB851P/TB853W(09-20)E
05.2.25, 11:26 AM
9