NEC multisync mt1035 사용자 설명서

45

This section helps you resolve problems you may encounter while setting up or using your MultiSync MT1035 LCD Projector.

m Normal

m The projector lamp has exceeded 2000 hours of operation and

should be replaced.

m Either the lamp cover or filter cover is not fastened properly. Check

each and reattach them if necessary.

m The projector is overheated.

• If there is insufficient ventilation around the projector or if the

room where you're presenting is particularly warm, move the
projector to a cooler location.

• Check the filter and clean it if necessary.
• If the problem persists, contact your NEC dealer for service.

OFF

On continually

Blinking very rapidly
(On and off in a cycle of 1 sec.)

Blinking rapidly
(On and off in a cycle of 4 sec.)

Blinking slowly
(On and off in a cycle of 8 sec.)

Blinking very slowly
(On and off in a cycle of 12 sec.)

m The cooling fan has stopped. Contact your NEC dealer for service.

m The lamp is not turned on.

• The projector was turned off and back on too quickly. Turn

off the projector, wait one minute, then turn the projector
back on. Or the lamp is burnt out.