Intermatic 158ha11645-art 사용자 설명서
Programming the Controller (continued)
After setting the day group and execution time, you will need to
choose which channels you want to control, and what you want
those channels to execute. The master controller can send
commands to modules to turn ON to full brightness, turn OFF,
turn ON to a pre-programmed brightness level (other than full
ON), or turn a SCENE ON.
choose which channels you want to control, and what you want
those channels to execute. The master controller can send
commands to modules to turn ON to full brightness, turn OFF,
turn ON to a pre-programmed brightness level (other than full
ON), or turn a SCENE ON.
Setting the Channels to Control, and Setting the Lighting Effect
(The Channel numbers and Dimmer Bars should
already be flashing.)
5. Press the Channel ON button of the channel that you
wish to program. (NOTE: For Channels 7-12, press the
SHIFT button). You may select more than one channel.
SHIFT button). You may select more than one channel.
6. (See Fig 14e on page 26) Set the lighting level by
pressing and holding the ALL OFF or ALL ON buttons
until the bars indicate the approximate desired light
level.
(See Fig 14f on page 26) If you would like to control
SCENES (the light levels that were established when
you originally set up the modules), press and release
ALL ON. Four dimming bars are displayed with spaces
in between each. Pressing ALL ON a second time will
selections.
until the bars indicate the approximate desired light
level.
(See Fig 14f on page 26) If you would like to control
SCENES (the light levels that were established when
you originally set up the modules), press and release
ALL ON. Four dimming bars are displayed with spaces
in between each. Pressing ALL ON a second time will
selections.
7. (See Fig 14g on page 26) Press ENTER to accept your
selections. Pressing ENTER will increase the event
number. Up to 28 events can be programmed into the
controller.
number. Up to 28 events can be programmed into the
controller.
Page 25 of 35