Dialogic M7324 사용자 설명서

external call forwarded on ring no answer and an external call 
forwarded on busy. If the Dialogic

®

 PBX Integration port is not 

set as the prime set, then forwarded external calls will appear as 
external forwarded on no answer. Programming the Dialogic

®

 

PBX Integration port as prime set is shown below. 

3.  Assign ring only to the first port of the Dialogic

®

 D/82JCT-U or 

D/42JCT-U Board for lines that are to be answered by the board, 
that is, direct into voice mail. For all lines that go directly to an 
extension, first have them “unassigned” for the ports on the 
board. 

4.  If lines are not being used, assign them to any pool except pool 

A. This impacts out dialing. 

Program the Dialogic

®

 PBX Integration port as Prime Set as follows: 

For Loop Start Lines: 

Line Access: 

Line Assignment: 

Line00N: unassigned  

Trunk/Line Data: 

Prime Set: First D/82 or D/42 extension number  

For DID Trunk Lines: 

Line Access: 

Line Assignment: 

<Trunk Line Number>: unassigned  

Trunk/Line Data: 

Line Type: public  
Rec’d #: Target Line Number  
If Busy: to prime  
Primeset: PBX integration port  

The following programming requirements are only required if: 
•  A DID trunk line is used with the Dialogic

®

 PBX Integration Board 

•  The target line number is needed in the caller ID information