Uniden BCT15 사용자 설명서
118
Fire Tone-Out Introduction
Your scanner can be set to respond to fire tone-outs, a system comprised of
standardized two-tone sequential paging, short one-tone paging, and long group
tone paging. You can save up to 10 settings. When you select a setting in standby
mode, the scanner also monitors for any other setting that uses the same transmit
frequency, modulation, and attenuation settings. To quickly switch to Fire Tone-Out
mode, press
standardized two-tone sequential paging, short one-tone paging, and long group
tone paging. You can save up to 10 settings. When you select a setting in standby
mode, the scanner also monitors for any other setting that uses the same transmit
frequency, modulation, and attenuation settings. To quickly switch to Fire Tone-Out
mode, press
F
and then press [SQ].
You need tone-out setup information from the agency you wish to monitor. Check
with your local agency or on-line resources as Uniden America Corporation has no
information regarding local tone-out systems.
with your local agency or on-line resources as Uniden America Corporation has no
information regarding local tone-out systems.
Setting Tone-Out Standby
[MENU]
Tone-Out for...
F
Tone-Out Standby
F
Turn the Scroll Control
to select which of the ten tone-outs to monitor. All
tone-outs that have the same frequency, modulation, and attenuation setting as
the one you select, are also monitored.
the one you select, are also monitored.
In standby mode, the display cycles through all monitored tone-out settings.
Regardless of the current display, the scanner always alerts on any received
tone-out that matches a stored setting.
Regardless of the current display, the scanner always alerts on any received
tone-out that matches a stored setting.
If you press [HOLD/RESUME] while in standby mode, the scanner temporarily
exits the mode and you hear all transmissions on that frequency. No alerts sound,
even if a tone-out matches one you have stored. Press [HOLD/RESUME] again to
return to standby mode.
exits the mode and you hear all transmissions on that frequency. No alerts sound,
even if a tone-out matches one you have stored. Press [HOLD/RESUME] again to
return to standby mode.
Setting Up Tone-Out
[MENU]
Tone-Out for...
F
Tone-Out Setup
F
Scroll to select the tone-out (1 - 10) you want to program, then press
F
.
Then you
can scroll to any of the following settings and press
F
to select and modify the
selected settings:
Edit Name — Sets the name for the selected tone-out setting.
Set Frequency — Sets the tone-out’s RF frequency parameters. Then select: